Setup and Add Devices to Beekeeper
These instructions will guide you through setting up your fleet and adding Bee LTE devices to your fleet
Beekeeper requires the Bee LTE model.
The Bee LTE devices you purchased should be already be added to your fleet when you receive them. If not, follow the steps below.
Setup your fleet
Install and activate a SIM
Once you have an active SIM card, it’s time to authenticate:
While the Bee is off, insert the SIM card into the designated SIM card slot
Power the Bee LTE on
Connect the (iOS: Bee Maps app / Android: Bee Maps app) with the Bee - leave it connected for 10 seconds
If successful, an in-app notification should appear “Now mapping with LTE”
Reboot the Bee LTE device
Opt into Beekeeper from Bee App
Connect the (iOS: Bee Maps app / Android: Bee Maps app) with the Bee LTE
From the Bee Maps App, click on Enable Beekeeper
If not prompted, go to Settings > Bee > Advanced and enable Beekeeper
Enter and verify your email address e.g.
[email protected]
Confirm the Bee is active
Open the Monitoring page on Beekeeper
The new Bee LTE device should appear in the Monitoring list view
Install the Bee in vehicle
See here for Bee install guide.
Add devices to your fleet
To add devices to your existing fleet, simply repeat step 1 and 2 above using the same email address you used in Step 2.
For example, in step 2, we used [email protected]
to create the Bob Logistics
fleet. So, we would use that same email address for future devices to auto-add them to our fleet.

Last updated